How To Make Pen drive Boot able Using Command Prompt

Today’s generation is very keen to know about this trending topic. So, here the post for all of you. This is only possible in Windows 7 and 8. Installing new operating system with CD/DVD have always a case of not working properly. As it takes so much time in doing that. So after reading this post you will get a handy solution for this. Today many laptops and computers comes with many USB ports. Now a day’s CD/DVD is now a quite history today most of the people uses USB’s for the installation of the operating system. The stage of formatting is performed very fast if you install an operating system using boot-able pen drives. Your pen drive can be boot-able by writing some codes in the command prompt in the Windows 7 and 8.

FOR WINDOWS 7 USERS:

Click on “Start” button and type “cmd“ and run it as administrator.

cmd,cmd promt,start button,cmd option

Next thing you have to do is just right click on the cmd icon and “Run as Administrator”.

right click,run as administrator,click on options

Now it will open a window of command dialog box.

cmd,cmd dialog,cmd dialog box,command prompt,command dialog,command dialog box,cmd as administrator,cmd running as adminstrator,command as administrator,command running as administrator

FOR WINDOWS 8 USERS:

Press windows button on your keyboard and then press “c”. You will able 2 see command prompt just right click on that and “Run it as Administrator”.

on windows 8,cmd,cmd prmopt,command prompt,cmd prompt in windows 8,command prompt in windows8

It will then open the cmd prompt.

Now the further steps are same in both Windows 7 and Window 8.

Write “diskpart” in the cmd dialog box.

disk part cmd,disk part command,performing disk part,performing disk part cmd,performing disk part command

Read More:-How To Check The Website is Safe To Open for You Or Not

It will be good for you that you should disconnect all the other external hard disk before going to the next step like pen/flash drives etc. there should be only one pendrive of minimum 4 GB should be plugged in or connected. save the existing data on your pen drive as it will be formatted in the following steps.

After completing the last step type “list disk” in the cmd prompt and hit enter.

Click Here To Read The Full Article

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s